HUDY 109470 - Alu Setup Wheels for 1/12 & 1/10 Pan Car

Setup wheels are always used when you want to eliminate the tolerance that exists in practice with a rim or a tire.

Especially with 1:12, the tire is a potent factor that can distort the measured values.
A foam rubber tire wears unevenly - a measurement with used conical tires is therefore not 100% accurate.
In order to enable exact and precise placement on a tweak board, the contact surface of an aluminum setup wheel is extremely small.

In addition, the aluminum wheels are always exactly straight and a camber measurement can also be carried out without distortion.

The diameter - measured on the O-ring that is clamped on the outside - is approx. 40.5mm.

The set includes two setup wheels - suitable for the 1/8 inch front axles of a typical 1:12 or Pro10 model.

There are also two knurled nuts so that you don't have to mess up the wheel nuts.

Important:
The system is NOT suitable for front axle designs such as the Awesomatix A12 (with a large diameter wheel axle).
A 1/8 inch wheel axle is required.