Square SEC-004 - PARSEC C - 1:10 PanCar - 200mm - Kit

We adopted 1/12 Pan Car front parts, developed aiming at a chassis that a wide range of users easily and enjoyably run while securing sharp movement and high rigidity.
Since it is compatible with parts for F103, ease of remodeling is also a feature. (PARSEC-C does not adopt FLEX CONTROL CARBON.)

-Hanging ceremony dedicated to the low-profile servo lowered to the lowermost surface of the chassis. Structure that does not interfere with roll (Only low profile servo can be used.)

-Although the upper decks are supported by the flange bearings and move in the roll direction Secure pitching rigidity.

-Split type steering crank capable of Ackerman adjustment in increments of 1 mm.

-It keeps high performance with FRP bar side link and roll tube damper.

-Light weight, low center of gravity New 70-75 motor mount and front and rear aluminum motor mount block.

-The pitching damper adopted Teflon piston, titanium coated shaft Aluminum expert type.

-Adjustable diff with wrench from outside the hub. Includes popular inch diff set which adopted large capacity thrust bearing. Sustain the effectiveness of the smooth diff defense for a long time.

-Full ball bearing specification.

​

-Specifications

Length：365mm
Width：183～196mm
Wheelbase：256～261mm

-Item requid

• 2ch propo with electric speed controller & 1servo radio controll set

• Battery Charger

• 3.4V or 7.4V Lipo Battery

• 540size motor

• Body

• F-1 Tire/Wheel

• 64pitch pinion gear

• Ball diff grease

• Silicon Oil

• Instant Glue​

* This kit is for low profile servo& Small servo only.